MBot3D Support
Always here to help

Mbot Cube Kit Wiring Diagram

Robin Shakya

 

Instructions

  1. Motherboard
  2. Power Supply
  3. Right extruder thermocouple. Two black wires. No distinguish Positive and negative.
  4. Right extruder cartridge heater cable. Two red wires. No distinguish Positive and negative.
  5. Right extruder fan cable. Connect red wire to “+”and black wire to“-".
  6. Left extruder thermocouple. Two black wires. No distinguish Positive and negative.
  7. Left extruder cartridge heater cable. Two red wires. No distinguish Positive and negative
  8. Left extruder fan cable. Connect red wire to “+”and black wire to"-".
  9. X-axis motor drive cable
  10. Y-axis motor drive cable
  11. Z-axis motor drive cable
  12. A or Right extruder motor drive cable
  13. B or Left extruder motor drive cable
  14. X-axis limit switch
  15. Y-axis limit switch
  16. Z-axis limit switch
  17. Control Button Panel and LCD Display
  18. LCD screen cable
  19. USB port
  20. Reset switch
  21. Allegro Chips. Check the direction of the TP1 and TP2 at Chip on the motherboard. TP2 should be facing towards the stepper motor jack. Wrong assemble may destroy chips and motherboard.

PS: For single head printer, right extruder is the default, 4 pcs motor drivers, respectively X,Y,Z,A

H2 cable each end jacks are same, but it should be connecting each other jack in opposite directions on Control button and the LCD Screen.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Open A Support Ticket