MBot3D Support
Always here to help

MBot Cube Kit calibration

Robin Shakya

  1. On Menu, Select Utilities and click on utilities. Select Jog Mode. Select Z axis and click on it.

 

  1. It will move upward direction until till it touch Z axis limit switch and stop

 

  1. Move extruder Right side check the gap between the building plate and nozzle. Gap between nozzle and build plate should be thickness of paper. Rotate the butterfly nut to adjust the gap between nozzles and build plate. Move extruder to left and front and repeat same process for adjusting the gap between nozzles and build plate.

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Open A Support Ticket